Siemens MC35 - Manual (Page 81)

AT Command Set
MC35_ATC_01_V03.02 Page 81 of 228 13.03.2002
4.20 AT+CLIR Calling line identification restriction (by *# sequence)
The AT+CLIR command is not supported. Instead, you can handle CLIR on a call-by-call basis using
the ATD command and a *# sequence.
Read command
ATD*#31#
Run the Read command to query status:
Response
+CLIR: ,
Defined values
(parameter shows the settings for outgoing calls):
0
presentation indicator is used according to the
subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
(parameter shows the subscriber CLIR service status in
the network):
0
CLIR not provisioned
1 CLIR provisioned in permanent mode
2 unknown (e.g. no network, etc.)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
Execute commands
ATD*31#[;]
ATD#31#[;]
The Execute commands allow you to enable or disable the presenta-
tion of your phone number to the called party when you set up a call:
Deactivate CLIR = enable presentation of own phone number
to called party
Activate CLIR = suppress presentation of own phone number to
called party
Note:
= phone number of called party