Siemens MC35 - Manual (Page 187)

AT Command Set
MC35_ATC_01_V03.02 Page 187 of 228 13.03.2002
8.19 AT^SNFD Set audio parameters to manufacturer default values
Test command
AT^SNFD=?
Response
OK
Execute command
AT^SNFD
Response
TA sets the active audio parameters to manufacturer defined default val-
ues.
OK
Reference
Siemens
Note
The restored values are: , , ,
, of all audio modes
8.20 AT^SNFI Set microphone path parameters
Test command
AT^SNFI=?
Response
^SNFI: (list of supported s), (list of supported brate>s) OK
Parameters
See write command
Read command
AT^SNFI?
Response
^SNFI: < inBbcGain >, OK
Parameters
See write command
Write command
AT^SNFI=,
Response
TA sets microphone path amplifying.
OK
Parameters
Setting for ADC gain Amplifier 0 - 7 (0=0dB, 7=42dB,
8 steps of 6 dB)
Multiplication factor 0 – 32767 for input samples at-
tenuation=20*log (inCalibrate/32767)
Reference
Siemens
Note
• Write command works only in audio modes 2 to 6!
• Read and write options of this command refer to the active audio
mode.
• The range of is up to 65535 but will be suppressed to
32767. Values above = 65535 will cause a failure
• Changed values have to be stored with ^SNFW.
• Attention! When you adjust audio parameters avoid exceeding the
maximum allowed level. Bear in mind that exposure to excessive lev-
els of noise can cause physical damage to users!
• The default values are customer specific.