Siemens MC35 - Manual (Page 19)

AT Command Set
MC35_ATC_01_V03.02 Page 19 of 228 13.03.2002
2.8 ATD> Originate call to phone number in memory with corre-
sponding field
This command searches the active phonebook for a given string and dials the assigned phone
number. The active phonebook is the one set with AT+CPBS.
Execute command
ATD>[mgsm][;]
TA attempts to set up an outgoing call to stored number
Note: This command may be aborted generally by receiving a character dur-
ing execution. It can´t be aborted in some connection setup states,
such as handshaking.
Response
If error is related to ME functionality:
+CME ERROR:
If no dialtone (parameter setting ATX2 or ATX4):
NO DIALTONE
If busy (parameter setting ATX3 or ATX4):
BUSY
If a connection cannot be set up:
NO CARRIER
If successfully connected and non-voice call:
CONNECT TA switches to data state.
Note: output only if +ATX parameter setting with value > 0.
When TA returns to command mode after call release:
OK
If successfully connected and voice call:
OK
Parameter
string type value (“x”), which should equal an alphanumeric field in
at least one phonebook entry in the searched memories; used char-
acter set should be the one selected with Select TE Character Set
+CSCS. can contain escape sequences as described in
chapter “Supported character sets“, pg. 11.
must be wrapped in quotation marks (""), if escape sequences
or parameter are used or if the alphanumeric strings con-
tains a blank. If not, quotation marks are optional.
I Activates CLIR (disables presentation of own phone number to
called party)
i Deactivates CLIR (enables presentation of own phone number to
called party)
<;> Only required to set up voice calls. TA remains in command mode.
Reference
V.25ter/GSM 07.07
Note
Command is not supported for data calls! See also ATX and Chapter 9.1.5 for