Siemens MC35 - Manual (Page 171)

AT Command Set
MC35_ATC_01_V03.02 Page 171 of 228 13.03.2002
8.3 AT^MONP Monitor neighbour cells
Test command
AT^MONP=?
Response
^MONP: (list of supported < period >s) OK
Write command
AT^MONP=[]
This command can be used to retrieve information of up to six neighbour
cells automatically every n seconds. It is cancelled by any character sent
to the serial port except if autobauding is enabled (+IPR=0). Then type
character ´a´ to abort.
Response
See execute command
Parameter
1 – 254 Display period in seconds
Execute command
AT^MONP
This command can be used to obtain information of up to six neighbour
cells on request.
Response (Example)
Parameter:
Chann Channel number
rs RSSI value 0 – 63 (RSSI = Received signal strength indication)
dBm Receiving level in dBm
PLMN PLMN ID code
BCC Base Station colour code
C1 coefficient for base station selection
C2 coefficient for base station selection
Reference
Siemens
Note
As a result of this command the requested output may be issued by the
ME at any moment (related to
). To indicate such unsolicited re-
sult codes to a connected application, the ME usually activates it´s Ring
Line (Logic "0") for one second. This is not true for output of AT^MONI and
AT^MONP.