At commands for fax, At+fbadlin bad line treshold, 3 at commands for fax – Siemens MC35 User Manual
Page 40: 1 at+fbadlin bad line treshold
AT Command Set
MC35_ATC_01_V03.02
Page 40 of 228
13.03.2002
3 AT Commands for FAX
The following commands can be used for FAX transmission.
If the ME is acting as a Fax-Modem to a PC-based application (e.g. “WinFax“) it is necessary to select
the proper Service Class (Fax Class) provided by the ME. The ME reports its Service Class capabili-
ties, both the current setting and the range of services avaible. This is provided by the AT+FCLASS
command (see pg. 42).
Note: When sending a FAX with a standard FAX application for Personal Computers it is recom-
mended to use autobauding (AT+IPR=0).
Currently defind Service Class values (see TIA/EIA-592-A)
ME
+FCLASS parameter
Service Class
Reference, Standard
+
0
data modem
e.g. TIA/EIA-602 or ITU V.25ter
+
1
Service Class 1
EIA/TIA-578-A
1.0
Service Class 1
ITU-T T.31
+
2
manufacture specific
this document and EIA PN-2388 (draft)
2.0
Service Class 2
TIA/EIA-592
2.1
Service Class 2
TIA/EIA-592-A or ITU-T T.32
8
Voice DCE
TIA IS-101
Reserved
Note: Be aware that there is a difference between Service Classes 2 and 2.0! Only the first is applica-
ble to the ME.
3.1 AT+FBADLIN Bad Line Treshold
Read command
AT+FBADLIN?
This command defines the “Copy-Quality-OK”-threshold. If
tive lines have pixel count errors in normal resolution (98 dpi) mode, then the
copy quality is unacceptable. If
errors in fine resolution (196 dpi) mode, then the copy quality is unacceptable.
“Copy Quality Not OK” occurs if either the error percentage is too high or too
many consecutive lines contain errors. A value of 0 implies that error checking
is not present or disabled.
Response
OK
Parameter
See write command
Write command
AT+FBADLIN=
Response
OK
If error is related to ME functionality:
ERROR
Parameter
0 – 10 – 255 bad lines
Reference
EIA PN-2388
Note
Used for Fax class 2 only