Siemens MC35 - Manual (Page 113)

AT Command Set
MC35_ATC_01_V03.02 Page 113 of 228 13.03.2002
4.42 AT+CSQ Signal quality
Test command
AT+CSQ=?
Response
+CSQ: (list of supported s), (list of supported ) OK
Parameter
See execute command
Execute command
AT+CSQ
Response
TA returns received signal strength indication and channel bit error rate
from the ME.
+CSQ: , OK
Parameter
Receive level:
0
-113 dBm or less
1 -111 dBm
2...30 -109... -53 dBm
31 -51 dBm or greater
99 not known or not detectable
Bit error rate:
0...7
as RXQUAL values in the table in GSM 05.08
section 8.2.4.
99 not known or not detectable.
To check the bit error rate there must be a call in progress to
obtain realistic values. If no call is set up, there is no BER to be
determined. In this case the indicated value may be 0 or 99,
depending on the SIM card.
Reference
GSM 07.07
Note