Siemens MC35 - Manual (Page 143)

AT Command Set
MC35_ATC_01_V03.02 Page 143 of 228 13.03.2002
6.1.2 AT+CGACT PDP context activate or deactivate
Test command
AT+CGACT=?
The test command is used for requesting information on the supported PDP
context activation states.
Response
+CGACT: (list of supported s)
OK/ERROR/+CME ERROR
Parameter
See write command
Read command
AT+CGACT?
The read command returns the current activation states for all the defined
PDP contexts.
Response
+CGACT: , [+CGACT: , ...]
OK/ERROR/+CME ERROR
Parameter
See write command
See write command
Write command
AT+CGACT=
[[,[,
[,...]]]]
This command is used to activate or deactivate the specified PDP con-
text(s). After the command has completed, the MT remains in V.25ter com-
mand state. If any PDP context is already in the requested state, the state
for that context remains unchanged. If the MT is not GPRS attached when
the activation form of the command is executed, the MT first performs a
GPRS attach and them attempts to activate the specified contexts. If no
s are specified the activation/deactivation form of the command acti-
vates/deactivates all defined contexts.
Response
OK/ERROR/+CME ERROR
Parameter
indicates the state of PDP context activation
0 – deactivated
1 – activated
PDP Context Identifier is a numeric parameter which
specifies a particular PDP context definition. The pa-
rameter is local to the TE-MT interface and is used in
other PDP context-related commands.
Note: The range of supported cids is returned by
AT+CGDCONT=?
Response
+CGACT: (list of supported s)
OK/ERROR/+CME ERROR
Reference
GSM 07.07
Note
Please note that the execution of ATH deactivates any PDP context (see
Chapters 2.12, 4.14, 6.3.2)