Siemens MC35 - Manual (Page 142)

AT Command Set
MC35_ATC_01_V03.02 Page 142 of 228 13.03.2002
6 GPRS AT commands in accordance with GSM 07.07
This chapter provides GPRS specific AT commands. For information on using GPRS commands in
multiplex mode see chapter 4.24.
6.1 Commands specific to MTs supporting GPRS
This clause defines commands that a TE (Terminal Equipment, i.e. an application running on a con-
trolling PC) may use to control a GPRS MT (Mobile Termination, the Wireless Module). Refer ro
Chapter 6.4 for selected examples of using GPRS AT commands.
6.1.1 AT+CGATT GPRS attach and detach
Test command
AT+CGATT=?
The test command is used for requesting information on the supported GPRS
service states.
Response
+CGATT: (list of supported s)
OK/ERROR/+CME ERROR
Parameter
See write command
Read command
AT+CGATT?
The read command returns the current GPRS service state.
Response
+CGACT:
OK/ERROR/+CME ERROR
Parameter
See write command
Write command
AT+CGATT=
[]
The execution command enables the MT get attached to or detached from the
GPRS service. After the command has completed, the MT remains in V.25ter
command state. If the MT is already in the requested state, the command is ig-
nored and the OK response is returned. Any active PDP contexts will be auto-
matically deactivated when the attachment state changes to detached.
If the MT is not able to attach for more than 5 minutes, the command returns an
error code, though the MT is still trying to attach.
Parameter
indicates the state of GPRS attachment
0 – detached
1 – attached
Response
OK/ERROR/+CME ERROR
Reference
GSM 07.07