Atl set monitor speaker loudness, Atm set monitor speaker mode, Ato switch from command mode to data mode – Siemens MC35 User Manual
Page 24: 15 atl set monitor speaker loudness, 16 atm set monitor speaker mode, 17 ato switch from command mode to data mode
AT Command Set
MC35_ATC_01_V03.02
Page 24 of 228
13.03.2002
2.15 ATL Set monitor speaker loudness
Execute command
ATL[val]
Response
OK
Reference
V.25ter
Note
• The two commands ATL and ATM are implemented only for V.25ter compati-
bility reasons and have no effect.
• In multiplex mode the command is supported on logical channel 1 only.
2.16 ATM Set monitor speaker mode
Execute command
ATM[val]
Response
OK
Reference
V.25ter
Note
• The two commands ATL and ATM are implemented only for V.25ter compati-
bility reasons and have no effect.
• In multiplex mode the command is supported on logical channel 1 only.
2.17 ATO Switch from command mode to data mode
Execute command
ATO[n]
Response
ATO is the alternative command to the +++ escape sequence described in Chap-
ter 2.2: When you have established a data call and TA is in command mode, ATO
causes the TA to resume the data connection and return to data mode.
If connection is not successfully resumed
NO CARRIER
or
TA returns to data mode from command mode
CONNECT
Note:
Parameter
0 switch from command mode to data mode
Reference
V.25ter
Note