Siemens MC35 - Manual (Page 190)

AT Command Set
MC35_ATC_01_V03.02 Page 190 of 228 13.03.2002
8.24 AT^SNFS Select audio hardware set
Test command
AT^SNFS=?
Response
^SNFS: (list of supported s) OK
Parameter
See write command
Read command
AT^SNFS?
Response
^SNFS: OK
Parameter
See write command
Write command
AT^SNFS=
The write command serves to set the audio mode required for the connected
equipment. Please note that the selected mode is not saved to the non-volatile
store and needs to be restored manually, if the GSM engine was powered down.
Response
OK
If error is related to ME functionality:
+ CME ERROR:
Parameters
1 Audio mode 1: Standard mode optimized for the default handset,
that can be connected to the analog interface 1 (see your
"Hardware Interface Description" for information on this hand-
set.) To adjust the volume use the knob of the default handset.
This handset can be used in audio mode 4 with user defined pa-
rameters.
Note: The default parameters are determined for type approval
and are not adjustable with AT commands.
2 Audio mode 2: Customer specific mode for a basic handsfree
device (Siemens Car Kit Portable) connected to the analog in-
terface 2. Audio parameters can be adjusted with AT commands
3 Audio mode 3: Customer specific mode for a mono-headset that
connects to the analog interface 2. Audio parameters can be
adjusted with AT commands.
4 Audio mode 4: Customer specific mode for a user handset that
connects to the analog interface 1. Audio parameters can be
adjusted with AT commands.
5 Audio mode 5: Customer specific mode intended for the analog
interface 1. Audio parameters can be adjusted with AT com-
mands.
6 Audio mode 6: Customer specific mode intended for the analog
interface 2. Audio parameters can be adjusted with AT com-
mands.
Reference
Siemens
Note