Siemens MC35 - Manual (Page 28)

AT Command Set
MC35_ATC_01_V03.02 Page 28 of 228 13.03.2002
2.27 ATS10 Set disconnect delay after indicating the absence of data carrier
Read command
ATS10?
Response
OK
Write command
ATS10=
This parameter setting determines the amount of time, that the TA remains con-
nected in absence of a data carrier. If the data carrier is detected before discon-
nect, the TA remains connected.
Response
OK
Parameter
001-002-254 number of tenths of seconds of delay
Reference
V.25ter
Note
2.28 ATS18 Extended error report
Test command
ATS18?
Response
OK
Execute command
ATS18=
TA returns an extended report of the reason for the last call release and location.
0 – 255, odd numbers set extended error report and even
numbers disable this feature.
Response
+Cause: : OK
Parameter
Location ID as number code (see subclause 9.1.6.
Reason for last call release as number code (see subclause
9.1.6).
Reference
Siemens
Note
This command works for data calls only. For voice calls please use AT+CEER.
2.29 ATT Select tone dialling
Execute command
ATT
Response
OK
Reference
V.25ter
Note
No effect for GSM