Siemens MC35 - Manual (Page 135)

AT Command Set
MC35_ATC_01_V03.02 Page 135 of 228 13.03.2002
Reference
GSM 07.05
Note
• Parameters =2,3 and =1 are only available with GSM phase 2+ (see
+CSMS=1). Incoming SMs or Status Reports have to be acknowledged with
AT+CNMA=0 when using these phase 2+ parameters.
• According to GSM 03.38 the ME treats short messages with message class 0
as though there was no message class, i.e. it will ignore bits 0 and 1 in the TP-
DCS and normal rules for exceeded memory capacity shall apply.
Requirements specific to Multiplex mode:
• In multiplex mode (AT+CMUX=0) only one channel can use a phase 2+ pa-
rameter. The parameter for and on the other channels have to be
set to zero.
• If either a SM or a Status Report is not acknowledged, all +CNMI parameter in
all channels will be set to zero.
5.11 AT+CPMS Preferred SMS message storage
Test command
AT+CPMS=?
Response
+CPMS: (list of supported s), (list of supported s), (list of sup-
ported s)
Parameter
See write command
Read command
AT+CPMS?
Response
+CPMS: ,,,,,,
,, OK
If error is related to ME functionality:
+CMS ERROR
Parameter
See write command
Write command
AT+CPMS=
[,
[,]]
Response
TA selects memory storages , and to be used for read-
ing, writing, etc.
+CPMS: ,,,,, OK
If error is related to ME functionality:
+CMS ERROR:
Parameter
Memory to be used when listing, reading and deleting messages:
“SM” SIM message storage
“ME” Mobile Equipment message storage
“MT” Sum of “ME” and “SM” storages
Memory to be used when writing and sending messages:
“SM” SIM message storage
“ME” Mobile Equipment message storage
“MT” Sum of “ME” and “SM” storages
Received messages will be placed to this storage if routing to TE is not
set. See AT+CNMI command with parameter =2 (Chapter 5.10).
“MT”
Sum of “ME” and “SM” storages