Siemens MC35 User Manual

Page 147

AT Command Set

MC35_ATC_01_V03.02

Page 147 of 228

13.03.2002

6.1.5 AT+CGQMIN Quality of Service Profile (Minimum acceptable)

Test command

AT+CGQMIN=?

The test command returns values supported as a compound value. If the
MT supports several PDP types, the parameter value ranges for each PDP
type are returned on a separate line.

Response

+CGQMIN: , (list of supported s), (list of sup-
ported s), (list of supported s) , (list of supported
s), (list of supported s) [+CGQMIN: ...]
OK/ERROR/+CME ERROR

Parameter

String parameter of Packet Data Protocol type
IP

See write command

Read command

AT+CGQMIN?

Response

The read command returns the current settings for each defined context. If
no minimum profile was explicitly specified for a context, simply OK will be
returned, but default values will be used for that context.

+CGQMIN: , , , , ,
[+CGQMIN: ...]
OK/ERROR/+CME ERROR

Parameter

See write command

Write command

AT+CGQMIN=
[[,
[,[,
[,[,]]]]]]

This command allows the TE to specify a minimum acceptable profile
which is checked by the MT against the negotiated profile returned in the
Activate PDP Context Accept message.
The set command specifies a profile for the context identified by the (local)
context identification parameter, .
A special form of the set command, +CGQMIN= causes the mini-
mum acceptable profile for context number to become undefined. In
this case no check is made against the negotiated profile.
AT&F and ATZ will undefine the minimum QoS profiles of every context
which is not active or not online.