At+cgqreq quality of service profile (requested), 6 at+cgqreq quality of service profile (requested) – Siemens MC35 User Manual

Page 151

AT Command Set

MC35_ATC_01_V03.02

Page 151 of 228

13.03.2002

6.1.6 AT+CGQREQ Quality of Service Profile (Requested)

Test command

AT+CGQREG=?

The test command returns values supported as a compound value. If the MT
supports several PDP types, the parameter value ranges for each PDP type
are returned on a separate line.

Response

+CGQREG: , (list of supported s), (list of sup-
ported s), (list of supported s), (list of supported
s), (list of supported s) [+CGQREG: ...]
OK/ERROR/+CME ERROR

Parameter

String parameter of Packet Data Protocol type
IP

See write command

Read command

AT+CGQREG?

The read command returns the current settings for each defined context. If
no requested profile was explicitly specified for a context, simply OK will be
returned, but default values will be used for that context.

Response

+CGQREG: , , , , ,
[+CGQREG: ...]
OK/ERROR/+CME ERROR

See write command

Write command

AT+CGQREG=
[[,
,[,[
,[,]]]]]]

This command allows the TE to specify a Quality of Service Profile that is
used when the MT sends an Activate PDP Context Request message to the
network.
The set command specifies a profile for the context identified by the (local)
context identification parameter, .
A special form of the set command, +CGQREQ= causes the re-
quested profile for context number to become undefined.
AT&F and ATZ will undefine the QoS profiles of every context which is not
active or not online.

Parameter

numeric PDP Context Identifier; if no cid is specified, nothing
will be changed (neither profile definition nor undefinition)
1
2