Siemens MC35 - Manual (Page 191)

AT Command Set
MC35_ATC_01_V03.02 Page 191 of 228 13.03.2002
8.25 AT^SNFV Set loudspeaker volume
Test command
AT^SNFV=?
Response
^SNFV: (list of supported s) OK
Parameter
See write command
Read command
AT^SNFV?
Response
^SNFV:
OK
Parameter
See write command
Write command
AT^SNFV=Step>
Response
TA sets the volume of the loudspeaker to the value addressed by
.
OK
Parameter
Volume range 0 to 4
Reference
Siemens
Note
• Read and write commands are related to the active audio mode.
• The changes are allowed in audio modes 2 to 6.
• can be changed by AT^SNFO, too.
• can be changed by AT^SNFO.
• AT^SNFW does not save the changed value. The setting will be
saved when you switch off the module with AT^SMSO.
8.26 AT^SNFW Write audio setting in non-volatile store
Test command
AT^SNFW=?
Response
OK
Execute command
AT^SNFW
Response
TA writes the active audio parameters in non-volatile store related to the active
mode.
OK
If error is related to ME functionality:
+ CME ERROR:
memory failure Flash write error
Reference
Siemens
Note
• Execute command works only in audio mode 2 to 6.
• TA writes the following audio parameter values in non-volatile store:
, , , ... brate[4]>,