Siemens MC35 - Manual (Page 80)

AT Command Set
MC35_ATC_01_V03.02 Page 80 of 228 13.03.2002
4.19 AT+CLIP Calling line identification presentation
Test command
AT+CLIP=?
This command refers to the GSM supplementary service CLIP (Calling Line
Identification Presentation) that enables a called subscriber to get the calling line
identity (CLI) of the calling party when receiving a mobile terminated call.
Response
+ CLIP: (list of supported s) OK
Parameter
See write command
Read command
AT+CLIP?
Response
+CLIP: , OK
If error is related to ME functionality:
+CME ERROR:
Parameter
See write command
Write command
AT+CLIP=
Set command enables or disables the presentation of the CLI at the TE. It has no
effect on the execution of the supplementary service CLIP in the network.
Response
OK
If error is related to ME functionality:
+CME ERROR:
Parameter
0 suppress unsolicited result codes
1 display unsolicited result codes
0 CLIP not provisioned
1 CLIP provisioned
2 unknown
Unsolicited result
code When CLIP is enabled at the TE (and is permitted by the calling subscriber), an
unsolicited result code is returned after every RING (or +CRING: ) at a
mobile terminating call.
Voice call response format:
+CLIP: , ,,,,
Data/FAX call response format:
+CLIP: ,
Parameter
string type phone number of calling address in format specified by
type of address octet in integer format; 145 when dialling string in-
cludes international access code character “+”, otherwise 129.
0 CLI valid
1 CLI has been withheld by the originator.
3 CLI is not available due to interworking problems or limitations
of originating network. shall be an empty string ("")
and value will not be significant.
Reference
GSM 07.07
Note