Siemens MC35 - Manual (Page 145)

AT Command Set
MC35_ATC_01_V03.02 Page 145 of 228 13.03.2002
6.1.4 AT+CGDCONT Define PDP Context
Test command
AT+CGDCONT=?
The test command returns values supported as a compound value. If the
MT supports several PDP types, the parameter value ranges for each
are returned on a separate line.
Response
+CGDCONT: (range of supported s), ,,,(list of supported
s), (list of supported s) [+CGDCONT: ...]
OK/ERROR/+CME ERROR
Parameter
See write command
See write command
numeric parameter that controls PDP data compres-
sion
0
off
numeric parameter that controls PDP header com-
pression
0
off
Read command
AT+CGDCONT?
The read command returns the current settings for each defined context. If
there is no context define simply OK will be returned.
Response
+CGDCONT: , , , , ,
[+CGDCONT: ...]
OK/ERROR/+CME ERROR
Parameter
See write command
See write command
See write command
See write command
See test command
See test command
Write command
AT+CGDCONT=[
[,[,
[,]]]]
This command specifies PDP context parameter values for a PDP context
identified by the (local) context identification parameter, . A special
form of the set command, +CGDCONT= causes the values for con-
text number to become undefined. AT&F and ATZ will undefine
every context which is not active or not online.
Parameter
This PDP Context Identifier is a numeric parameter
which specifies a particular PDP context definition.
The parameter is local to the TE-MT interface and is
also used in other PDP context-related commands. If
no cid is given, nothing will be changed (neither con-
text definition nor undefinition).
1
2