Siemens MC35 - Manual (Page 46)

AT Command Set
MC35_ATC_01_V03.02 Page 46 of 228 13.03.2002
3.10 AT+FDIS Query or set session parameters
Test command
AT+FDIS =?
This command allows the controlling application to sense and constrain the
capabilities used for the current session. It uses +FDIS to generate DIS or
DTC messages directly, and uses +FDIS and received DIS messages to gen-
erate DCS messages.
Response
(list of s), (list of
s), (list of s), (list of s), (list of s),
(list of s), (list of s), (list of s)
Parameter
See write command
Read command
AT+FDIS?
Response
<cdec> OK
Parameter
See write command
Write command
AT+FDIS =
,
,,
,,,
,
Response
OK
Parameter
Vertical Resolution VR 0 normal, 98 lpi
1 fine, 196 lpi
Bit Rate BR 0 2400 bit/s, V.27ter
1 4800 bit/s, V.27ter
2 7200 bit/s, V.29
3 9600 bit/s, V.29
Page Width WD 0 *) 1728 pixels in 215mm
1 2048 pixels in 255 mm
2 2432 pixels in 303 mm
3 1216 pixels in 151 mm
4 864 pixels in 107 mm
Page Length LN 0 A4, 297mm
1 B4, 364mm
2 unlimited length
Data Compression Format DF 0 *) 1-D modified Huffman
1 2-D modified read
2 2-D uncompressed mode
Error correction EC 0 *) disable ECM
(Annex A/T.30) 1 enable ECM, 64 bytes/frame
2 enable ECM, 256 bytes/frame
Binary File mode BF 0 *) disable BFT
Transfer Mode 1 enable BFT
Scan Time/Line ST 0 *) 0 ms (at VR= normal)
1 5 ms
2 10 ms
3 10 ms
4 20 ms
5 20 ms
6 40 ms
7 40 ms
*) Note: Only the default value needs to be implemented. Use test command
to check which parameter values are really possible!
Reference
EIA PN-2388
Note
Used for Faxclass 2 only