Enterasys Networks 2200 - Manual (Page 82)

Access Control List Screen
4-26 Device Configuration Menu Screens
7. Use the arrow keys to highlight the SAVE command and press ENTER. The message “SAVED
OK” displays on the screen.
The designated workstations will now receive traps from the SmartSwitch device as long as the
communication path to the designated workstations is not inhibited (for example, by subnets or
VLANs).
4.6 ACCESS CONTROL LIST SCREEN
When to Use
To view, enable, or disable the Access Control List (ACL). Enabling the ACL provides additional
security by limiting access to the SmartSwitch device to a maximum of 16 IP addresses. To
manage an ACL enabled SmartSwitch device, the management station must be a member of the
ACL and authenticated according to traditional SNMP rules.
When the ACL is disabled, host access is not restricted.
How to Access
Use the arrow keys to highlight the ACCESS CONTROL LIST menu item on the SNMP
Configuration Menu screen, and press ENTER. The Access Control List screen,
Figure 4-11 ,
displays.
NOTE: Exiting without saving causes a “NOT SAVED?” message to appear above the
SAVE command. Edits are lost if they are not saved before exiting.
NOTE: Clearing NVRAM will remove all IP address entries and return the access
control state to Disable.