Enterasys Networks 2200 - Manual (Page 42)

Password Screen
3-6 Accessing Local Management
3.2 PASSWORD SCREEN
When to Use
To start a Local Management session. Local Management is controlled through the Local
Management Password screen shown in
Figure 3-3 . Whenever a connection is made to the
SmartSwitch device the Local Management Password screen displays. Before continuing, you
must enter a password (community name), which is compared to the previously stored passwords.
The level of access allowed the user depends on the password. To set or change passwords, refer to
Section 4.4 .
How to Access
1. Turn on the terminal. Press ENTER (this may take up to four times, because the COM port of
the SmartSwitch device auto-senses the baud rate of the terminal) until the Local Management
Password screen displays.
Figure 3-3 shows the Password screen.
Screen Example
Figure 3-3 Local Management Password Screen
xxxxx-xx LOCAL MANAGEMENT
Enterasys Systems, Incorporated
P.O.Box 5005
Rochester, NH 03866-5005 USA
(603) 332-9400
(c) Copyright Enterasys Networks, Inc. 2001
Device Serial Number: XXXXXXXXX
Device Hardware Revision: XX
Device Firmware Revision: XX.XX.XX
Device BOOTPROM Revision: XX.XX.XX
SecureFast VLAN Revision: XX.XX.XX
Enter Password:
30692_04