Enterasys Networks 2200 - Manual (Page 26)

Local Management Screen Elements
1-4 Introduction
1.4 LOCAL MANAGEMENT SCREEN ELEMENTS
There are six types of screens used in Local Management: password, menu, statistics,
configuration, status, and warning screens. Each type of screen can consist of one to five basic
elements, or fields.
Figure 1-1 shows an example of the fields in a screen. A description of each
field follows the figure.
Figure 1-1 Example of a Local Management Screen
NOTE: The following definitions apply to most of the Local Management screens.
Exceptions to these definitions may occur in the Local Management screens of some
devices.
Firmware Revision: XX.XX.XX
General Configuration
25042_14w
BOOTPROM Revision: XX.XX.XX
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr: Device Date:
Device Time:
Screen Refresh Time:
Screen Lockout Time:
Clear NVRAM [NO]
Device Uptime XX D XX H XX M
IP Fragmentation [ENABLED]
Operational Mode: [802.1Q SWITCHING]
25042_14w
Event Message Field Display Field
Input Fields
Selection Field Command Fields
Display Fields
XXXX-XX LOCAL MANAGEMENT
Event Message Line
RETURN SAVE
10/11/97
14:23:00
30 sec.
15 min.
EXIT
00-00-ID-00-00-00
0.0.0.0
255.255.0.0
NONE DEFINED
0.0.0.0
See
Note
Note:
This shows the location of the cut away that is used in most of the screen graphics in this
document. The top portion of the screen is cut away to eliminate repeating the same
information in each graphic.The screen title is contained in its figure title.
Heading