Enterasys Networks 2200 - Manual (Page 248)

Built-in Commands
11-12 Network Tools Screens
cdp
Description: Allows management of Cabletron Discovery Protocol (CDP) on this module.
The user may enable, disable, or see the current status of CDP.
Syntax: cdp [enable/disable/status]
Options: None
Example: -> cdp status
CDP is Enabled
-> cdp disable
-> cdp status
CDP is Disabled
-> cdp enable
-> cdp status
loopback_detect
Description: The loopback_detect command allows the user to enable, disable or check the
current state of loopback detection on Ethernet front panel ports.
The user must specify the state as enable, disable or status.
The state field is mandatory.
Syntax: loopback_detect [enable | disable]
Options: enable – Enables loopback detection on Ethernet front panel ports.
disable – Disables loopback detection on Ethernet front panel ports.
status – Indicates if loopback detection is enabled or disabled.
Example: -> loopback_detect enable
-> loopback_detect disable
-> loopback_detect status
Loopback_detect is disabled.