Enterasys Networks 2200 - Manual (Page 72)

General Configuration Screen
4-16 Device Configuration Menu Screens
2. Press the SPACE bar to choose either ENABLED or DISABLED. The COM port must be
ENABLED for the LM or UPS application. Selecting DISABLED disallows the COM port
connection to the terminal, providing additional device security.
Figure 4-6 COM Port Warning
3. Use the arrow keys to highlight YES. Press ENTER.
4. If the port was ENABLED, the message “SAVED OK” appears, and the edits are saved. If the
port was DISABLED, use the arrow keys to highlight SAVE at the bottom of the screen, then
press ENTER.
CAUTION: If the COM port is reconfigured without a valid IP address set on the
SmartSwitch device, the message shown in
Figure 4-6 displays.
Do not continue unless the outcome of the action is fully understood.
NOTE: Exiting without saving causes the message “NOT SAVED -- PRESS SAVE TO
KEEP CHANGES” to appear. Exiting without saving causes all edits to be lost.
WARNING
30691_12
THE COM PORT HAS BEEN RECONFIGURED AND THERE IS NO IP
ADDRESS SET FOR THIS DEVICE. YOU WILL NO LONGER BE ABLE
TO MANAGE THIS BOARD. DO YOU STILL WISH TO RECONFIGURE
THIS COM PORT?
YES NO