Enterasys Networks 2200 - Manual (Page 106)

HSIM/VHSIM Configuration Screen
5-12 Port Configuration Menu Screens
5.4 HSIM/VHSIM CONFIGURATION SCREEN
When to Use
To configure an optional HSIM or VHSIM.
How to Access
Use the arrow keys to highlight the HSIM/VHSIM CONFIGURATION menu item on the Port
Configuration Menu screen and press ENTER. The applicable HSIM or VHSIM setup screen
displays. Refer to the appropriate HSIM or VHSIM user’s guide for instructions on using the Local
Management screens for that interface.
5.5 REDIRECT CONFIGURATION MENU SCREEN
When to Use
To access the Port Redirect Configuration and VLAN Redirect Configuration screens. Any
combination, up to 128, of port and/or VLAN redirect instances can be configured from these
screens.
NOTE: The HSIM/VHSIM Configuration menu item can only be selected when a
non-Ethernet HSIM or VHSIM is installed in the SmartSwitch device. When selected, the
applicable setup screen for that interface displays. This only applies to HSIMs and
VHSIMs that can support WAN, FDDI or ATM. Refer to the appropriate HSIM or VHSIM
user’s guide to set its operating parameters.
NOTE: If the device is operating in the SecureFast Mode, the Port Redirect
Configuration screen will display instead of the Redirect Configuration Menu screen.
The VLAN Redirect Configuration screen is not available in SECURE FAST VLAN
mode.