Enterasys Networks 2200 User Manual
Page 62
General Configuration Screen
4-6
Device Configuration Menu Screens
Subnet Mask
(Modifiable)
See the subnet mask for the SmartSwitch device. A subnet mask
“masks out” the network bits of the IP address by setting the bits in the
mask to 1 when the network treats the corresponding bits in the IP
address as part of the network or subnetwork address, or to 0 if the
corresponding bit identifies the host. When an IP address is entered in
the IP Address field, the Subnet Mask field automatically changes to
the default subnet mask for that IP address. For details about how to
change the subnet mask from its default value, refer to
Default Gateway
(Modifiable)
See the default gateway for the SmartSwitch device. This field is not
defined until an appropriate value is entered. For details about why and
how to set the Default Gateway, refer to
.
TFTP Gateway IP
Addr
(Modifiable)
See the TFTP Gateway IP address for the SmartSwitch device. To set
the TFTP Gateway IP address, refer to
Device Date
(Modifiable)
Enter a new device date. To enter a new date, refer to
Device Time
(Modifiable)
Enter a device new time. To enter a new time, refer to
.
Screen Refresh
Time
(Modifiable)
Enter a new device time. This setting determines how frequently (in
seconds) information is updated on the screen. To enter the refresh
time, refer to
.
Screen Lockout
Time
(Modifiable)
Enter a new lockout time. This is maximum number of minutes that the
Local Management application displays a screen while awaiting input
or action from a user. For example, if the number 5 is entered in this
field, the user has up to five minutes to respond to each of the specified
device’s Local Management screens.
In this example, after five minutes of no input or action, the terminal
“beeps” five times, the Local Management application terminates the
session, and the display returns to the Local Management Password
screen.
To enter the screen lockout time, refer to
.
Table 4-2
General Configuration Screen Field Descriptions (Continued)
Use this field…
To…