1 setting a port to operate using gmrp or gvrp, 2 setting all ports on the switch, Setting a port to operate using gmrp or gvrp -7 – Enterasys Networks 2200 User Manual
Page 213: Setting all ports on the switch -7, Section 8.2.1, Section 8.2.2
GARP Configuration Screen
GARP Configuration Menu Screens
8-7
8.2.1
Setting a Port to Operate Using GMRP or GVRP
To set a port to be a GMRP- or GVRP-aware port. Proceed as follows:
1. Use the arrow keys to highlight the GMRP or GVRP field of the port.
2. Press the SPACE bar to choose Y (yes).
3. Repeat steps 1 and 2 above to set the GMRP and GVRP of ports as necessary.
4. Use the arrow keys to highlight the SAVE command.
5. Press ENTER. The message “SAVED OK” displays and all settings are saved.
8.2.2
Setting All Ports on the Switch
All ports on the switch can be set at one time to one mode of operation using the Set All Ports
field.
To select the mode of operation using the Set All Ports field, proceed as follows:
1. Use the arrow keys to highlight the Set All Ports field.
2. Press the SPACE bar to select one of the following:
•
GMRP Enable All
•
GMRP Disable All
•
GVRP Enable All
•
GVRP Disable All
•
Enable All
•
Disable All
3. Press ENTER.
4. Use the arrow keys to highlight the SAVE command at the bottom of the screen.
5. Press ENTER. The message “SAVED OK” displays.
NOTE: Only ports set as hybrid ports may be configured as GVRP ports. To set a port
to the hybrid mode of operation, refer to
.