Enterasys Networks 2200 - Manual (Page 251)

Built-in Commands
Network Tools Screens 11-15
Example: -> gigabit_port_mode status
gigabit_port_mode is redundant
-> gigabit_port_mode active
This will reset board and cause loss of persistent objects except IP Address
and Subnet: Are you *SURE* ?
vrrpPort
Description: Enables the user to choose the Virtual Router Redundancy Protocol (VRRP)
Port(s), front panel Ethernet or Fast Ethernet ports.
When the link on a VRRP Port goes down or up, the database is purged. Then
a notification is sent out to all LAN emulation clients (LECs) connected to the
local HSIM/VHSIM to clear their LEARP cache. Clearing the databases
causes the removal of old information and forces the 2H252-25R devices to
establish new virtual connections based on the new router paths.
NOTE: This command is valid only when an HSIM-A6DP or
VHSIM-A6DP is installed in the SmartSwitch device.
Syntax: vrrpPort [ get ]
vrrpPort [ set ] [ port# ]
vrrpPort [ unset] [ port# ]
vrrpPort [ set ] [all]
vrrpPort [ unset] [all]
gigabit_port_mode (Continued)