Enterasys Networks 2200 - Manual (Page 66)

General Configuration Screen
4-10 Device Configuration Menu Screens
4. Use the arrow keys to highlight the SAVE command, then press ENTER. The warning screen
shown in Figure 4-4 displays.
Figure 4-4 Configuration Warning Screen, Subnet Mask
5. Use the arrow keys to highlight the YES command, then press ENTER. The changes are saved
and the device reboots.
4.2.3 Setting the Default Gateway
If the SNMP management station is located on a different IP subnet than the SmartSwitch device,
a default gateway must be specified. When an SNMP Trap is generated, the SmartSwitch device
sends out an ARP request to the default gateway, which responds with its MAC address. The
SmartSwitch device then sends the trap using the IP address from the Trap Table and the MAC
address of the default gateway. To set the default gateway, perform the following steps:
1. Use the arrow keys to highlight the Default Gateway field.
2. Enter the IP address of the default gateway using the DDN format.
For example: nnn.nnn.nnn.nnn
WARNING!
30691_09
YOU HAVE ELECTED TO SAVE ONE OR MORE CONFIGURATION
ITEMS THAT REQUIRE RESETTING THIS DEVICE.
ARE YOU SURE YOU WANT TO CONTINUE?
YES NO