Enterasys Networks 2200 - Manual (Page 204)

Protocol Port Configuration Screen
7-36 802.1Q VLAN Configuration Menu Screens
7.8.1 Assigning Ports to a VID/Classification
The following procedures describe how to
• assign one or more ports to a Classification Rule,
• set all ports simultaneously to a Classification Rule, or
• enable all selected ports to forward frames with the Classification Rule by adding that
Classification Rule to the Port VLAN List of each port.
Port
(Read-Only) See the number of each port.
Classify
(Toggle) See which ports are set to the VID/Classification displayed in the
Classification Rule field above the Port and Classify column headings.
This field toggles between YES and NO, which determines whether or
not the associated port is set to the VID/Classification indicated in the
Classification Rule field.
NOTE: As each Classify field is highlighted, the Event
Message Line (not shown) at the top of the screen indicates the
port type. For example: Fast Ethernet Front Panel, and Gigabit
Ethernet VHSIM.
If a port cannot be configured, NO will be displayed without
brackets.
SET ALL PORTS
(Toggle) Set all ports to the VLAN and Classification shown in the
Classification Rule field. The SET ALL PORTS field toggles between
NO and YES with NO as the default setting. YES associates all ports
set to YES to the VID/Classification shown in the Classification Rule
field.
SET PORTS TO
VLAN
FORWARDING
(Toggle) Add the VLAN and classification shown in the Classification Rule
field to the Port VLAN List of all ports set to YES. The SET PORTS
TO VLAN FORWARDING field toggles between NO and YES with
NO as the default setting. YES adds all the ports set to YES to the
VLAN Forwarding list of the SmartSwitch device.
Table 7-9 Protocol Port Configuration Screen Field Descriptions (Continued)
Use this field … To …