Enterasys Networks 2200 - Manual (Page 116)

Broadcast Suppression Configuration Screen
5-22 Port Configuration Menu Screens
5.8 BROADCAST SUPPRESSION CONFIGURATION SCREEN
When to Use
To set the limit on received broadcast frames that are switched out to other ports.
How to Access
Use the arrow keys to highlight the BROADCAST SUPPRESSION CONFIGURATION menu
item in the Port Configuration Menu screen and press ENTER. The Broadcast Suppression
Configuration screen,
Figure 5-7 , displays.
Screen Example
Figure 5-7 Broadcast Suppression Configuration Screen
NOTE: The Broadcast Suppression Configuration screen is not available if the
operational mode of the device is set to SECURE FAST VLAN. This screen can only be
used when the device is configured to operate as an 802.1Q switch.
Section 4.2.9
describes how to set the operational mode.
Broadcast frames received above the threshold setting are dropped.
30691_26
PORT #
1
2
3
4
5
6
7
8
9
10
11
12 Time Since Peak
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59
999:23:59 Peak Rate
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000 Threshold
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000
150000 Total RX
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910
12345678910 Reset Peak
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
[NO]
RETURN
RETURN SAVE EXIT NEXT PREVIOUS