Radius – Enterasys Networks 2200 User Manual
Page 257
Built-in Commands
Network Tools Screens
11-21
Example:
-> dynamic_egress status 1
Dynamic Egress Disabled for VLAN ID 0x0001
-> dynamic_egress enable 1
Dynamic Egress Enabled for VLAN ID 0x0001
-> dynamic_egress disable 1
Dynamic Egress Disabled for VLAN ID 0x0001
radius
Description:
Used to enable, disable, and configure the radius function. Radius
authentication is only used when the client has been properly configured and
enabled. When the Radius Client is not enabled, the legacy password
authentication will run as before. For more about Radius Client, refer to
.
Syntax:
radius
radius status
radius [enable | disable]
radius prim_ip
radius sec_ip
radius timeout
radius retry
radius clear
radius prim_auth_port
radius sec_auth_port
radius prim_acct_port
radius sec_acct_port
radius last_resort < [local|remote] [accept|reject|challenge] >
radius prim_secret
radius sec_secret
dynamic_egress (Continued)