Enterasys Networks 2200 - Manual (Page 215)

GMRP Configuration Screen
GARP Configuration Menu Screens 8-9
Field Descriptions
Refer to Table 8-3 for a functional description of each screen field.
8.3.1 Setting a Mode, Port-by-Port
To set the Mode of operation for a particular port, proceed as follows:
1. Use the arrow keys to highlight the Mode field of a particular port.
2. Press the SPACE bar to select one of the following modes of operation:
• Use GMRP Filter Unreg
• Forward All Groups
• Filter All Groups
• Use GMRP Forward Unreg
3. Repeat steps 1 and 2 as necessary to select the mode for other ports.
4. Use the arrow keys to highlight the SAVE command at the bottom of the screen.
5. Press ENTER. The message “SAVED OK” displays and all modes selected are saved.
Table 8-3 GMRP Configuration Screen Field Descriptions
Use this field… To…
Port # (Read-Only) See the number of the front panel interfaces.
Mode
(Selectable) Select one of the following four modes of operation.
Use GMRP Filter Unreg – Do not forward frames out this port that
have an unregistered multicast address.
Forward All Groups – Regardless of multicast address registration,
send frames out this port.
Filter All Groups – Regardless of multicast address registration, do
not send frames out this port.
Use GMRP Forward Unreg – Forward all frames out this port that
have an unregistered multicast address.
The default setting for this field is “Use GMRP Filter Unreg”.
For details on selecting a mode, refer to Section 8.3.1 .
Set All Ports
(Selectable) Set all ports to one mode simultaneously. The selection is the same as
shown for the Mode field.