Enterasys Networks 2200 - Manual (Page 65)

General Configuration Screen
Device Configuration Menu Screens 4-9
Figure 4-3 Configuration Warning Screen, IP Address
5. Use the arrow keys to highlight the YES command, then press ENTER. The changes are saved
and the device reboots.
4.2.2 Setting the Subnet Mask
If the management workstation that is to receive SNMP traps from the SmartSwitch device is
located on a separate subnet, the subnet mask for the SmartSwitch device may need to be changed
from its default value.
To change the subnet mask from its default, perform the following steps:
1. Use the arrow keys to highlight the Subnet Mask field.
2. Enter the subnet mask into this field using Dotted Decimal Notation (DDN) format.
For example: 255.255.0.0
3. Press ENTER. If the subnet mask is valid, the cursor returns to the beginning of the Subnet Mask
field. If the entry is not valid, the screen displays the message “INVALID SUBNET MASK OR
FORMAT ENTERED”. Local Management does not alter the current value, but it does refresh
the Subnet Mask field with the previous value.
WARNING!
30691_09
YOU HAVE ELECTED TO SAVE ONE OR MORE CONFIGURATION
ITEMS THAT REQUIRE RESETTING THIS DEVICE.
ARE YOU SURE YOU WANT TO CONTINUE?
YES NO