Enterasys Networks 2200 - Manual (Page 223)

IGMP/VLAN Configuration Procedure
Layer 3 Extensions Menu Screens 9-7
9.3 IGMP/VLAN CONFIGURATION PROCEDURE
To set up IGMP protocol for VLANs, proceed as follows:
1. Use the arrow keys to highlight the VLAN ID field, and use the SPACE bar to step through the
VLAN choices to find the correct VLAN to configured. ALL may be chosen to affect all
VLANs seen by the device.
2. Use the arrow keys to highlight the IGMP State field.
3. Use the SPACE bar to select ENABLED, DISABLED, ENABLE ALL or DISABLE ALL. If a
specific VLAN was chosen in step 1 , ENABLED and DISABLED are used to enable or disable
the VLAN chosen. ENABLE ALL and DISABLE ALL are used to enable or disable all
available VLANs at one time, regardless of whether a specific VLAN was chosen or if ALL was
chosen in
step 1 .
4. Use the arrow keys to highlight the Default for new VLANS field.
5. Use the SPACE bar to toggle the setting to either ENABLED or DISABLED to set the default
for new VLANs.
6. Use the arrow keys to highlight the IGMP Version field. Then use the SPACE bar to select the
proper IGMP version for the VLAN shown in the VLAN ID field. If ALL was chosen as the
VLAN ID, this version change will affect all VLANs seen by the device.
IGMP State
(Selectable) See the current state of the VLAN indicated in the VLAN ID field,
which can be modified. Use the SPACE bar to step through the choices:
ENABLED, DISABLED, ENABLE ALL, DISABLE ALL. The
commands ENABLED and DISABLED will act only on the VLAN
whose ID is in the VLAN ID field. The commands ENABLE ALL and
DISABLE ALL act on all VLANs available to the SmartSwitch.
Default for new
VLANS
(Toggle) Set up new VLANs be to be either ENABLED or DISABLED by
default. Either a specific VLAN can be set up, by choosing the number
of a specific VLAN, or all at the same time, by choosing ALL in the
VLAN ID field.
NOTE: When configuring IGMP, it is advisable to follow the IGMP configuration rules in
RFC 2236 concerning switches, and routers.
Table 9-2 IGMP/VLAN Configuration Screen Field Descriptions (Continued)
Use this field… To…