Yaskawa MotionSuite Series Machine Controller Software Manual User Manual
Page 453

MotionSuite™ Series Machine Controller Software Manual
Chapter 14: Command List
14-1
14 Command List
This chapter provides information on the command list for drawing/function cre-
ation.
14.1 Command List for Drawing/Function Creation ................................................ 14-2
14.1.1
Program Control Commands ................................................................... 14-2
14.1.2
Direct Input Commands ........................................................................... 14-3
14.1.3
Ladder Circuit Commands ....................................................................... 14-3
14.1.4
Logical Operation Commands ................................................................. 14-4
14.1.5
Numerical Operation Commands ............................................................ 14-4
14.1.6
Numerical Conversion Commands .......................................................... 14-5
14.1.7
Numerical Comparison Commands ......................................................... 14-5
14.1.8
Data Operation Commands ...................................................................... 14-6
14.1.9
Basic Function Commands ...................................................................... 14-7
14.1.10 DDC Commands ...................................................................................... 14-7
14.1.11 Table Data Operation Commands ............................................................ 14-8