Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 217)

MotionSuite™ Series Machine Controller Software Manual Chapter 7: System Data Definition
7-44
5. Used
Input a name of 32 16-bit characters (16 32-bit characters) or less. 16-bit and 32-
bit characters may be combined in the same name.
6. Equipment
Input a name of 32 16-bit characters (16 32-bit characters) or less. 16-bit and 32-
bit characters may be combined in the same name.
7. Usage
Input a name of 32 16-bit characters (16 32-bit characters) or less. 16-bit and 32-
bit characters may be combined in the same name.
8. Date Prepared
Input a name of 48 16-bit characters (24 32-bit characters) or less. 16-bit and 32-
bit characters may be combined in the same name.
9. Revision History
Input a name of 48 16-bit characters (24 32-bit characters) or less. 16-bit and 32-
bit characters may be combined in the same name. Up to 15 data rows may be
input into the revision data history.
7.6.3 Saving Application Information
This function saves the application information data. The data is saved into both the
PLC and hard drive in the on-line mode, and into the hard drive only in the off-line
mode. Save the application information data as follows:
a. Select Save (S) from File (F) in the application data menu.
b. Select the Yes (Y) button from the message box.
Note:
An error message box is displayed in the event of a failed save. Remove the cause of the
error, and repeat save.
7.6.4 Closing Application Information
Close application information setting by closing the application information window.
To close the window, select Close (C) from File (F) in the application information
menu.