Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 313)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-65
8.3.3 Constant Table ( # register) Data Input
Constant tables (# register) are created by inputting parameters (integers, 32-bit inte-
gers, real numbers), symbols, and # register numbers. When storing a constant table
(# register), the parameters are automatically converted to a # register following an
upper/lower limit check. Table data can be created up to a number of number registers
set in the DWG Configuration tab in the Property Window.
1. Data Name
Input a name for each parameter of 48 16-bit characters (24 32-bit characters) or
less. 16-bit and 32-bit characters can be combined within names.
2. Symbol
Input a symbol pertaining to the # register to be stored of 8 16-bit characters (4
32-bit characters) or less. 16-bit and 32-bit characters can be combined within
names.
3. Set Val
Input the parameters to be stored in the # register. If the input is hexadecimal,
attach an H to the beginning of the value such as in “H00FF.” Input numerical
values within the range as an upper/lower limit check; the data set in the Upper
Limit and Lower Limit boxes executed upon setting input.
4. Unit
Input parameter units of 8 16-bit characters (4 32-bit characters) or less. 16-bit
and 32-bit characters can be combined in this entry.
5. Lower Limit
Input the parameter lower limit.
6. Upper Limit
Input the parameter upper limit. Input so that Lower Limit ≤ Upper Limit.
7. Save Point
Input the # register number to which the parameters are to be stored.
1 2 3 4 5 6 7