Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 295)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-47
d. Input the coil command.
e. Select the OFF pulse command.
f. Input the register number, which is the operand of the OFF pulse command.
g. Input the coil command
5. Timer Circuit Creation
Create the timer circuit programs by designating the following three points.
• Signs for branch points, join points, and join connections.
• Time limit setting parameters or register numbers for time limit setting.
• Register numbers for calculations.
a. Input the normally closed (NC) contact command.
b. After selecting the ON delay command, set the branching and join points.
1 0000 IB00000 MB00970 0B00000
1 0000
IB00000
0B00000
1 0003
MB009970
MB009971
0B00001
1 0000
IB00000
0B00000
1 0003
MB009970
MB009971
0B00001
1 0000 IB00000
0B00000
1 0003
005.00
IB000001
1 0005
MW00010
T
Timer Circuit
IB000002
1 0000
IB00000
T