Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 241)

MotionSuite™ Series Machine Controller Software Manual Chapter 7: System Data Definition
7-68
6. Failure Name
Input a failure name of 48 16-bit characters (24 32-bit characters) or less. 16-bit
and 32-bit characters can be combined within names.
Editing of Fault Configuration Data
Input fault configuration data can be edited in row units.
a. Insert Row
This function inputs a desired number of blank rows into the table.
a.1 Drag the cursor from the point where rows are to be inserted for the amount
of rows to be inserted.
a.2 Select Insert (I) from Edit (E) in the Failures menu.
a.3 Select the Yes button in message box.
a.4 Blank rows are inserted in front of the position selected in (a.1).
b. Delete Rows
This function deletes a number of connected rows in the table.
b.1 Drag the cursor from the point where rows are to be deleted up to the end
line of the deletion.
b.2 Select Delete (D) from Edit (E) in the Failures menu.
b.3 Select the Yes button in the message box.
b.4 The rows selected in (b.1) are deleted.
c. Cutting of Row Data
This function cuts a number of connected rows in the table. The cut data is cop-
ied into the cut buffer. The contents of the cut buffer can be repeatedly copied
using the Paste function.