Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 151)

MotionSuite™ Series Machine Controller Software Manual Chapter 6: Module Configuration
6-7
12. Output Disable
13. Motion Start Register
6.2.3 Saving the Module Configuration
Follow the steps below to save the Module Configuration file.
a. Select File (F) → Save (S) from the menus.
b. Choose the Yes button in the message box when confirming the message
contents.
Setting Value Status
Empty Enable
D Disable
E Disable cannot be designated
Status Meaning
Empty The module is not being installed. The slot is empty.
Not installed The module is defined, but not installed yet.
Running The module is operating normally.
Standing by The module is on standby.
Error The error in the module is detected.
X Module Name The different module from the definition is installed.
Waiting for Initialization The module is installed, but not defined yet.
Stopped The module stopped.
Stop (Replacement is not allowed) —
Replacement Ready Replacement switch is ON; the LED is lit.
While Dual Operating (Control System) Possesses control privilege while dual operating
While Dual Operating (Standby System) Possesses no control privilege while dual operating