Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 296)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-48
c. Input the time limit setting values (parameters or register numbers) which are
ON delay command operands.
d. Input calculation register numbers which are ON delay command operands.
e. After selecting the normally open (NO) contact command, set the branch and
join points.
f. Input the register numbers which are operands of the normally open (NO) con-
tact command.
g. Input the coil command.
h. Input the normally open (NO) contact command.
1 0000
IB00000
T
005.00
1 0000
IB00000 005.00 MW00010
T
1 0000
IB00000
1 0003
005.00 MW00010
T
1 0000
IB00000
1 0003
005.00 MW00010
T
0B00000
IB000001
1 0000
IB00000
0B00000
1 0003
005.00
IB000001
1 0005
MW00010
T
IB000002