Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 333)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-85
Creation of New C Register Tables
This item presents the creation of new C registers. After creating a C register, open its
C register table window.
a. Select New (N) from File (F) in the C register list menu.
b. In the dialogue box, input the table name, starting register number, size, and
comments, then select the OK button.
c. Open the C register table window specified in (b).
Note:
Input a table name of 8 16-bit characters (4 32-bit characters) or less. 16-bit and 32-bit
characters may be combined in the name. Input a starting register number between
CW0 ~ CW16383, and 16284 or less in proportion to the size. Starting register num-
bers and sizes that duplicate other C register areas cannot be input.
8.5.3 Structure of C Register Table Window
Opening of the C register table window, and its menu structure are presented here.
Opening of C Register Table Window
Open the C register table window. The C register tables stored in the PLC in the on-
line mode, and in the hard drive in the off-line mode, are called out. See Item 8.5.2
“Table Operation with the List Window” for further information on opening the C reg-
ister table window.