Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 282)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-34
g. Select the FIN command. The function input parameters and A numeric com-
mand are connected.
h. Input the register number (or parameter).
Address Input
Program the address inputs as follows.
i. Select the FIN command.
j. Input the register number.
Output
Program the bit form (defined by B-VAL) output as follows.
k. Select the FOUT command. The function output parameters and coil command
are connected.
l. Input the coil command.
1 0005
IN-3 OUT-3
FIN ========> =>
1 0005 MW00020
IN-3 OUT-3
FIN ========> =>
1 0005
ADDRESS
1 0005
ADDRESS
MA01000
IN-1 OUT-1
1 0001 MB00001 FIN FOUT
IN-1 OUT-1
1 0001 MB00001 FIN FOUT MB000002