Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 289)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-41
If a circuit is connected in parallel with a deleted element, it remains open following
deletion of the command.
Supplement:
Deletion of a number of commands containing a relay circuit.
If a number of commands containing a relay circuit are deleted, select the delete area
start position at the power connection command, and the delete area end position at the
coil command.
3. Cut
This function cuts a command. Data cut in this way is copied to the cut buffer. The
contents of the cut buffer can in turn be recopied using the Paste command.
a. Move the cursor to the cut start position.
b. Select CUT (X) from the Edit (E) menu. “CUT,” which signifies the cut mode,
is shown at the bottom of the window.
c. Move the cursor to the cut end position. The area to be cut is highlighted.
d. Select CUT (X) from the Edit (E) menu.
e. The area designated in steps (a) and (b) is cut.
Note:
The cut mode can be released without cutting any commands by pressing the ESC key
when in the cut mode. When a command is cut using the cut function, there is no
power column compensation similar to that in the delete mode.
4. Copy
This function copies a command to the cut buffer. The contents of the cut buffer can in
turn be recopied using the Paste command.
1 0002
I B00000
0B00000
1 0004 MB004900
SGL02
MB006801
1 0002 IB00000
0B00000
1 0004
SGL02
MB006801
MB004900
1 0002
M B006801
SGL02