Yaskawa MotionSuite Series Machine Controller Software Manual - Manual (Page 251)

MotionSuite™ Series Machine Controller Software Manual Chapter 8: Ladder Programming
8-3
8.1 Property Settings
This section deals with the setting methods for ladder program comments, # register num-
bers, history updates, etc.
8.1.1 Configuration of the Property Window
Menus and page tabs in the property window are discussed below.
Opening the Property Window
Open the property window as described below. This calls up the property data stored
in the PLC if in the on-line mode, and on the hard disk if in the off-line mode.
a. First, as the properties are set into the programs, see which programs are applica-
ble to this setting by referring to item 8.2.1.
b. Select Open (O), Drawings (R), and Property (R) from the File (F) menu.
c. The property window for the programs opened in (a.) are displayed.
Supplement:
Properties are set into the main program of open source drawing or function . There-
fore, when properties for another drawing or function are set, it is necessary to open
the main program for it.
Configuration of Property Window Menus
The program menu displayed in the property window is the same as that for the ladder
program window. See Item 8.2.1 “Configuration of Ladder Program Window”.
Property Window Page Tabs
The tab controls for the property window differ for drawing programs and function
programs. The item numbers in the right-hand columns of tables 1 and 2 refer to sec-
tions of the MotionSuite™ Series Machine Controller Software Manual.
Table 1: Drawing Property Window Tab Control
Tab Name Function Item Number
DWG Configuration Defines ladder program structure data 8.1.2
Symbol Definition Defies drawing program symbols 8.1.4
# Register List Sets ladder program registers 8.1.5
Update History Displays ladder update history 8.1.6