Grass Valley K2 AppCenter v.9.0 - Manual (Page 54)

This is displayed over the event that is in progress. dashed red line
This event is pending, on the timeline and ready to begin at the specified
time. blue text
This icon is displayed beside absolute events in the list. Use it to hide or
show the events after it. expand/contract icon
Configuring a channel for remote control
You can configure a channel for remote control either locally or through a network-connected
Control Point PC. Operating remote control from AppCenter provides extended features that allow
local and remote control at the same time.
You can select a remote protocol to use with individual channels.
To modify the remote protocol setting for a channel:
1. Click on the channel whose protocol you want to specify.
2. Select Control | Options . The Options dialog box displays.
3. If it is not already displayed, select the Control tab.
4. Select the desired protocol and remote settings, and click OK . If using VDCP protocol to control
transfers, you must set up the video network and the Controller ID.
NOTE: The protocol control port is pre-set and cannot be modified.
5. Test the system and recheck settings, if required.
Description Protocol Mode
Allows you to monitor the record or play channel
operations and view clip information locally
only. There is no control from any external
device. Local only
Allows you to monitor the record or play channel
operations and view clip information only using
remote protocol. All control comes from the
external device. The buttons, menu items, and
other interface controls are disabled. You can
select this mode by choosing the Remote only
option in the Options dialog box Remote only
Allows you to control the record or play channel
locally as well as remotely. You can select this
mode by choosing Remote and Local in the
Options dialog box. Local and Remote
Related Topics
Controlling transfers with VDCP on page 220
54 K2 AppCenter User Manual 29 October 2012
Using AppCenter