Grass Valley K2 AppCenter v.9.0 - Manual (Page 178)

Configure live streaming multicast
This task describes using AppCenter to configure multicast settings. You can also use the K2Config
application to configure multicast settings on SAN-attached K2 Summit systems. Refer to related
topics in "K2 System Guide".
1. In AppCenter, click File | System | Configuration .
Configuration Manager opens.
2. In Configuration Manager, click the System tab.
These setting apply to all channels on the K2 Summit system.
3. In Proxy Setup settings, select the multicast IP base.
The K2 Summit system applies channel-specific IP addresses from this base.
Your choices are constrained to those specified by IANA for multicast.
4. Select the multicast port base.
This is the first UDP port address for elementary streams.
5. Click OK to apply the settings.
178 K2 AppCenter User Manual 29 October 2012
Audio/Video Configuration