Security and protocol control – Grass Valley K2 AppCenter v.9.0 User Manual
Page 222
protocols can also use Ethernet connections.) You can connect one RS-422 cable to each channel.
Each RS-422 connection controls the channel to which it is connected only. Connect the RS-422
cabling as required, then refer to topics in this document to configure the K2 system for remote
control.
Specifications for the RS-422 connection are as follows:
•
Data Terminal Equipment (DTE)
•
38.4K Baud
•
1 Start bit
•
8 Data bits
•
1 Parity bit
•
1 Stop bit
Related Topics
Configuring a channel for remote control
on page 54
Security and protocol control
The K2 security features can be configured to restrict protocol control of channels.
222
K2 AppCenter User Manual
29 October 2012
Remote control protocols
This manual is related to the following products: