Teac DM-24 - Manual (Page 97)

12 – MIDI—Control Change messages to and from the DM-24
TASCAM DM-24 Reference Manual
97
To access this facility, use the CTRL. CHANGE (Control
Change) screen of the MIDI/MC group, with the
fourth soft key providing access to this screen:
Use POD 4 to choose the option that will be affected
by the selected Control Change numbers.
Since there are 32 channels and only 16 MIDI chan-
nels, there must be some mapping performed. It is
not possible, for example, to use the MIDI volume
Control Change (07) to affect the fader values of all
32 channels of the DM-24.
As shown here, each target (channel and value) is
associated with both a MIDI channel and a MIDI
Control Change number. These are edited using the
cursor keys, dial and
ENTER key.
NOTE
The following Control Changes are not available for use
with this function: 0, 6, 32, 38, and 96 through 127.
If two channels have been linked, the even-numbered
channel of the pair is represented by upward-pointing
arrows, and no assignment can be made to it, since it
will use the assignment of the odd-numbered mem-
ber of the pair.
If a MIDI Channel/Control Change combination has
already been used, a popup message appears (
MIDI
Chx [Control No. y] is already assigned. ). Press ENTER
to dismiss this popup message.
The above assignments apply to the first three
options:
Ch. Fader (fader), Ch. Pan (pan) and Ch. Mute
(mute). For the other options, the situation changes a
little:
If the Master option is selected, the fader values and
mute settings for the buss and for the aux sends are
displayed, as well as the main STEREO fader value.
Assign MIDI channels and Control Change numbers
to these parameters.