Teac DM-24 - Manual (Page 101)

13 – Library functions—Managing library entries
TASCAM DM-24 Reference Manual
101
3 Use POD 4 to scroll through the list of entries
in the library.
4 Press soft key 4 or the dedicated RECALL key
to recall the entry.
If there is no data in the library entry, a
popup message appears to show this, and no
data is recalled.
Library undo/redo
When library entries are recalled (“Library func-
tions” on page 99), the
2ND F. key pressed together
with the RECALL key acts as an undo key, allowing
the recently recalled library setting to be compared
with the previously-loaded library setting.
Setting and editing titles
The DM-24 provides titling facilities for the library
entries. These are available when an entry is first
stored, or when the
EDIT soft key (3) is pressed from
the library screen.
Library entries may have a name consisting of up to
16 characters.
Use POD 4 to scroll through the list of library entries.
When a library entry is stored it is given a default
name (for instance
FROM CH12 would be used to
describe an EQ setting which had been saved from
the current settings on channel 12).
If the entry highlighted in the list at the right of the
screen already has a name which is to be edited, use
the dial to pick the
ÄNAME special command and
press ENTER . This copies the entry name to the
name editing area.
Use the cursor keys to navigate the cursor around the
name editing area on the left of the screen.
Pick letters and symbols from the list below the name
editing area. Press
ENTER to insert the highlighted
symbol into the name editing area.
It is also possible to use the SCREEN MODE /
NUMERIC ENTRY keys to enter numbers directly
into the title.
Use the special commands as follows:
INSERT – inserts a space at the cursor position
DELETE – deletes the character at the cursor position
<-NAME – as explained above, this copies the existing
name of the highlighted data entry to the name edit-
ing area.
NAME-> – this copies the edited name to the high-
lighted entry in the list at the right of the screen.
Xtion-> and <-Xtion – snapshots only. This is not part
of the name, but represents the transition time to load
a snapshot. This is edited using POD 2 and can be set
from 0.0 seconds to 9.9 seconds, in 0.1 second inter-
vals. Use these two on-screen options to move the
transition time from and to the editing area, respec-
tively.
When the name is edited, use the STORE soft key (2)
to store the name (and the transition time in the case
of snapshots). Note that this does not store the snap-
shot, but only the name, etc.
Use the CANCEL soft key (3) to cancel the name edit-
ing operation.